Tune before you run wsjt. The ATU I think forces the VFO into CW mode. Split in a DATA Mode is not allowed if one VFO is not in same DATA Mode.
Sent from my iPhone ...nr4c. bill > On Sep 10, 2020, at 12:57 PM, David Needham <[email protected]> wrote: > > Bill, > > It looks like you have uncovered the same apparent firmware glitch I did. I > have verified a few friends have the same issue. It is very repeatable on > K3 and K3S's. > > I was using split mode for WSJT-X and when I would press Tune while in Data > Mode A to tune my KPA-1500, I get zero power output. If I take the rig out > of Split mode, it works just fine. Put it back Split mode, still works > fine. Turn the rig off and on again, zero power out again. > > My solution was also to run WSJT-X in Fake It mode, but I really would > prefer to be able to use Split mode. Maybe one day one of the firmware > updates will correct that. > > -- > Thank you! > David Needham, AA4VT (formerly K4AJA and K8AJA) > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
