No this is the VFO knob... turning the VFO knob when calibrate the S HI
and S Lo paramater should be use to adjust the bar led display for
proper receivng indication. If turning the VFO knob does nothing, you
should probably have something wrong...
Gary Marks a écrit :
Under S-Meter Alignment:
The forth step says:
Turn RF Gain fully counter-clockwise. Adjust the VFO knob until bargraph
segment 9 lights, then turn it a bit more counter-clockwise until segment 10
just turns on (right-most segment).
Question: Should this have said RF Gain instead of VFO knob ? Turning the VFO
does nothing while turning the RF Gain knob performs what the instructions say.
Comments please......
Gary
WD8ICX
K2 #5609
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
