Gary Marks wrote: > The forth step says: Turn RF Gain fully counter-clockwise. Adjust the > VFO knob until bargraph segment 9 lights, then turn it a bit more > counter-clockwise until segment 10 just turns on (right-most > segment). > > Question: Should this have said RF Gain instead of VFO knob ? > Turning the VFO does nothing while turning the RF Gain knob performs > what the instructions say.
Even if you're in "CAL S HI"? You might need to turn AGC off (hold PRE/ATT and AGC) before you start CAL S HI and CAL S LO. -- "Nosey" Nick Waterman, G7RZQ, K2 #5209. use Std::Disclaimer; [EMAIL PROTECTED] Please sponsor me! http://www.justgiving.com/noseynick Anything worth doing is worth doing badly. -- G. K. Chesterton _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com