I should have done as in the first step....after entering the menu again and
selecting CAL S HI, I should have done:
Hold "EDIT" a second time to activate it. That sentence wasn't in the manual
and I'm just learning the procedures with this rig. Everything checked out
OK. On to Assembly, Part II.
THANKS
Gary
You missed one prior step - enter the menu and edit 'CAL S Hi' first, and
then the VFO knob should work as described - you should see a display like
'S HI 018' (the number will change as you rotate the VFO knob).
73,
Don W3FPR
-----Original Message-----
Under S-Meter Alignment:
The forth step says:
Turn RF Gain fully counter-clockwise. Adjust the VFO knob until
bargraph segment 9 lights, then turn it a bit more
counter-clockwise until segment 10 just turns on (right-most segment).
Question: Should this have said RF Gain instead of VFO knob ?
Turning the VFO does nothing while turning the RF Gain knob
performs what the instructions say.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
