On 7/5/2021 12:48 PM, Jack Brindle via Elecraft wrote:
Do you really need the 15-pin AUXIO cable? The ANAN doesn’t speak Auxbus, so
unless it outputs the BCD signals that the KPA500 (but not the KAT500) uses,
then the AuxIO cable won’t do you any good. Remember, the KPA and KAT do not
communicate. Instead you will need a pair of phono to phono cables for the PTT
signal, and perhaps a serial cable to go to the KPA500 if the ANAN speaks
Kenwood protocol.
Take a very good look at the current KPA500 manual for more information, and
make sure you can use the AUXIO cables before investing in them.
73,
Jack, W6FB
You will need an RS232 crossover cable between the ANAN 7000 and the
KPA500. In the 7000 software you have to use a CAT+ control and
connect the RS232 cable to the XCVR
connector on the KPA500. I don't know how to connect the KAT500 to
the 7000.
73 Tom AA4VV
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
