I have a K3,KAT500 and KPA500. I had a station on 10 Meters this
afternoon that I wanted to reach.
The KPA500 did not work on 10M as if it was in standby mode (it was
not), the KAT500 tuner didn't tune either the K3 showed 1.0-1 5W all
across the 10m band but no relays clicks in the KAT500. I tested after
this happened and both work as expected on all other bands. It has been
years since I used 10M. The firmware is current on all three units.
Any thoughts or ideas.
TIA
Larry NA0F
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
