That sounds right, so the PS is working OK.
According to the manual you need only 3.5 - 7 W drive for 100W output.
Have you checked that 3dB attenuator, Pin, RF Drive, is in the OUT/AUTO
position?
Bert VE3NR
On 2022-10-18 14:57, Kyle Krieg wrote:
I don't have anything that would draw 20A's, but I do have an FT-891 and I
think the power supply is good.
FT-891 puts out 98W on full key down with PS reading around 15.3A output in
the same setup as the KX3/KXPA100.
Kyle
______________________________________________________________
Elecraft mailing list
Home:http://mailman.qth.net/mailman/listinfo/elecraft
Help:http://mailman.qth.net/mmfaq.htm
Post:mailto:[email protected]
This list hosted by:http://www.qsl.net
Please help support this email list:http://www.qsl.net/donate.html
Message delivered [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
