For some reason the latest Errata hasn't been posted to the web site, but it should be shipped with the kits (D-4, December 2, 2006). In any case, the 11-16 ohm spec is correct for both Q1 and Q2 base to ground.
Ron (whose finger slipped on the key that day) AC7AC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Darwin, Keith Sent: Saturday, December 23, 2006 1:10 PM To: [email protected] Subject: RE: [Elecraft] KPA100 Final Transistor base resistance Maybe. When I did my Rev D KPA100 a few weeks ago, only ONE of the resistances was changed to read 11 - 16 in the errata. The other still said 12 - 16. Maybe the errata has been update in the last few weeks? In my case, both transistors measured 11.5 ohms and the rig works fine. 73! - Keith N1AS - - K2 5411.ssb.100 - ________________________________ From: [EMAIL PROTECTED] on behalf of Don Wilhelm Sent: Sat 12/23/2006 12:25 PM To: Kevin Schmidt; [email protected] Subject: RE: [Elecraft] KPA100 Final Transistor base resistance Kevin, You are OK - check the Rev D manual and its errata sheet and you will find the range has been changed to 11 to 16 ohms. 73, Don W3FPR _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
