Hi all,
Well I have finally started looking for the fault on my SSB board after
about 9 months! For some reason I have no receive when the board is
plugged in. If I short out pins 1 and 3 of J9 and J10 I get receive no
problem, so it would appear to be a fault on the SSB board.
I have checked the crystals to ground, all seems OK. I have checked the
voltages on the pin diodes and again, all would seem well. In fact,
other than a few small stray voltages, the only major anomaly I can find
is a voltage on U4-3 of 6V on receive. The manual states 0.6 volts.
I would love any thoughts to point me in the right direction please?
73 Ian
--
Ian J Maude G0VGS
SysOp GB7MBC DX Cluster
Member of RSGB, ARRL, GQRP
K2 #4044
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
