Yea, it is a mess. I have one bridge, but I think that is where they
come together anyway (the tail end of three of the resistors right next
to the connector) because I can't get it cleared up. If I have problems
that are on that circuit, it will be the first place I look.
David Wilburn
[EMAIL PROTECTED]
Chuck wrote:
Dave,
It's tight, but everything will fit. Be sure the leads coming out of the
thermistor board bend immediately 90 deg to the RF board.
Also take a good long hard look at your solder joints on that little thing. The holes are not clad, so solder does not flow there like the rest of the kit.
My only problem with the whole kit was a joint on the thermistor board. I
looked at it several times and signed it off as good. I had to do a great deal
of disassmbly to find out that was my problem afterall.
I just finished up my K2/100 yesterday and enjoyed my first QSOs last night.
Chuck K4QS
_______________________________________________
No banners. No pop-ups. No kidding.
Make My Way your home on the Web - http://www.myway.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
