I am good to go then, as the one to the right is in good shape. I
followed up with the measurement and all is well.
David Wilburn
[EMAIL PROTECTED]
Don Wilhelm wrote:
Dave,
If you look at the back of the thermistor board, there is one place where 3
resistors come together just above pins 4 and 5, those are connected
together. OTOH, a bit toward the right of that point you will see two
resistors with the ends pointing at each other and the PC traces are quite
close together - those should NOT be connected, it is easy to create a
solder bridge at that point. If you want a resistance check, read the value
between pins 5 and 6 - if it is zero, you have the solder bridge.
73,
Don W3FPR
-----Original Message-----
Yea, it is a mess. I have one bridge, but I think that is where they
come together anyway (the tail end of three of the resistors right next
to the connector) because I can't get it cleared up. If I have problems
that are on that circuit, it will be the first place I look.
David Wilburn
[EMAIL PROTECTED]
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.17.28/672 - Release Date: 2/6/2007
10:22 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
