Dave, If you look at the back of the thermistor board, there is one place where 3 resistors come together just above pins 4 and 5, those are connected together. OTOH, a bit toward the right of that point you will see two resistors with the ends pointing at each other and the PC traces are quite close together - those should NOT be connected, it is easy to create a solder bridge at that point. If you want a resistance check, read the value between pins 5 and 6 - if it is zero, you have the solder bridge.
73, Don W3FPR > -----Original Message----- > > Yea, it is a mess. I have one bridge, but I think that is where they > come together anyway (the tail end of three of the resistors right next > to the connector) because I can't get it cleared up. If I have problems > that are on that circuit, it will be the first place I look. > > David Wilburn > [EMAIL PROTECTED] > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.432 / Virus Database: 268.17.28/672 - Release Date: 2/6/2007 10:22 AM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
