On 9/3/07, k4zm <[EMAIL PROTECTED]> wrote: > It sounds like you have the bottom plate mounted 180 degrees out or have not > installed the bail assy. The bottom should be installed so that the bail > assy is located near the front of the K2. Also if mounted 180 degrees out I > don't think you can install the two screws in the middle of the bottom > cover. These are important in making the PLL a stable unit.
Nope, everything is installed correctly. Bail was a pain to install but I finally got it installed just fine. It isn't off by much but noticeable when sitting flat on the desk. It's probably a 1/16th or 1/32nd shorter in the front but I haven't measured yet so maybe my eyes are playing a trick on me. -- JT Croteau, N1ESE - Manchester, NH _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
