JT:
To give you another data point, I just measured my K2 (#5413) and it is
slightly *higher* in the front. With the bail not extended and measuring
from the bottom of the side panels to the tabletop at the front and rear.
Front Clearance ~15/32 in
Rear Clearance ~27/64 in
Both +/- eyeball error. Both sides were about the same.
73,
Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
JT Croteau wrote:
On 9/3/07, k4zm <[EMAIL PROTECTED]> wrote:
It sounds like you have the bottom plate mounted 180 degrees out or have not
installed the bail assy. The bottom should be installed so that the bail
assy is located near the front of the K2. Also if mounted 180 degrees out I
don't think you can install the two screws in the middle of the bottom
cover. These are important in making the PLL a stable unit.
Nope, everything is installed correctly. Bail was a pain to install
but I finally got it installed just fine. It isn't off by much but
noticeable when sitting flat on the desk. It's probably a 1/16th or
1/32nd shorter in the front but I haven't measured yet so maybe my
eyes are playing a trick on me.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
