JT,
Measure your rear feet. Perhaps you have the wrong ones - but I do not
know of other Elecraft products that use different size feet (although
the K3 may have higher feet).
I just measured 3 K2s with my shop dial caliper. My old SN 20 front
feet measure 0.430 inches and the rear feet are 0.410 (maybe from slight
compression over the years). SN 586x has 0.430 front feet and the rear
feet measure 0.427 inches and SN 619x has 0.430 front feet and the rear
feet are 0.425 inches. So all will have a very slight back tilt.
I can think of only 2 possibilities - one is that you mounted the
lockwashers between the feet and the rear panel (they should be next to
the nuts on the inside), or two is that somehow your rear feet are
incorrect due to some mixup in parts.
73,
Don W3FPR
Nope, everything is installed correctly. Bail was a pain to install
but I finally got it installed just fine. It isn't off by much but
noticeable when sitting flat on the desk. It's probably a 1/16th or
1/32nd shorter in the front but I haven't measured yet so maybe my
eyes are playing a trick on me.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
