Good afternoon I get trouble taking my new XV144 into operation (with K2 S/N 4546, S/W 2.04P). 1. 40/60 m function : OK 2. Transverter function : I cannot get full milliwatt power. Holding TUNE with a 50 ohm load across the XVR-OUT, the display reads a power range from 0.1 mW to 0.17 mW and then does'nt increase further. The bargraph displays low power as well ( 2 bars). Keying the transmitter in CW mode, the display is OK, but the bargraph has the same behavior. I verified all what is possible to verify (diodes, R, C etc) but didn't find anything wrong.
Any ideas ? Thanks for your possible help. 73 Luc/F6HJO/HB9ABB _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
