Luc,
Do you have the KAT2 installed? If so, did you change KAT2 R6 to 470
ohms as instructed?
If you did change it, remove the KAT2 ribbon cable and see if the K60XV
behaves normally.
If no KAT2, is there anything else connected to the K2 control board P4
header? If so, remove it and re-test the K60XV for power output.
73,
Don W3FPR
luc wrote:
Good afternoon
I get trouble taking my new XV144 into operation (with K2 S/N 4546, S/W
2.04P).
1. 40/60 m function : OK
2. Transverter function : I cannot get full milliwatt power. Holding TUNE
with a 50 ohm load across the XVR-OUT, the display reads a power range from
0.1 mW to 0.17 mW and then does'nt increase further. The bargraph displays
low power as well ( 2 bars). Keying the transmitter in CW mode, the display
is OK, but the bargraph has the same behavior.
I verified all what is possible to verify (diodes, R, C etc) but didn't find
anything wrong.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
