Thanks for quick reply, Don
> Do you have the KAT2 installed? If so, did you change KAT2 R6 to 470 > ohms as instructed? > If you did change it, remove the KAT2 ribbon cable and see if the K60XV > behaves normally. Answer : no KAT2 at all (I knew this change but n/a) > If no KAT2, is there anything else connected to the K2 control board P4 > header? If so, remove it and re-test the K60XV for power output. Answer : nothing is connected (no PA, nothing...) 73 Luc > > 73, > Don W3FPR > > luc wrote: > > Good afternoon > > I get trouble taking my new XV144 into operation (with K2 S/N 4546, S/W > > 2.04P). > > 1. 40/60 m function : OK > > 2. Transverter function : I cannot get full milliwatt power. Holding TUNE > > with a 50 ohm load across the XVR-OUT, the display reads a power range from > > 0.1 mW to 0.17 mW and then does'nt increase further. The bargraph displays > > low power as well ( 2 bars). Keying the transmitter in CW mode, the display > > is OK, but the bargraph has the same behavior. > > I verified all what is possible to verify (diodes, R, C etc) but didn't find > > anything wrong. > > > > > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
