Has anyone seen this error? Using the "K3 Firmware Update Downloader (Version 1.0.11.21)" i get always the same problem with the function "save K3 configuration as" under the tab "configuration". The saving proccess stops unpredictable.
In a small portsniffer output i can see that the response from the K3 is alright referring to the format. But some characters are wrong, which seems to be the reason why the software stops the process. Inside the stored file you can find "*error reading EEPROM at ...". My K3 has the current MCU and DSP software installed and i've checked it with all available baud-rates. Based on the fact that my previous firmware upgrades were successful i would assume it is not a problem with the interface. Any comments ? Thanks, Thomas, DM7TN s/n 78 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
