Up to the point where I am trying to do the 'TX Gain Calibration'. (Everything to this point in time has gone exactly as expected; I have calibrated the Synthesizer successfully, and set up (and rechecked) the filter settings to match the actual crystal filters instllaed).
Here is the problem. When I follow the TX Gain instructions on Page 46 of the owner's manual, I find a few problems: 1) when I press the ANT button, VFO B says 'NO ATU' .. probably not an error, since I am in ATU Bypass error. I guess I was a little confused by the wording: Switch to ANT1 by tapping ANT. since I never see the K3 talking to ANT2 ... 2) The real problem is that after setting the power to "exactly 5.0 watts" and holidng TUNE, the power reading on 160 meters only goes to 1.2 watts; when I tap TUNE to exit, VFO B says: ERR TXG. Similar problems on other banads, to wit: 1.8 Watts on 80m, 1.4 Watts on 40m, 1.9 Watts on 20m, etc. I am stuck! Helppppp! Thanks. ------------------------------------------------------------ This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email. ================================= _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
