Thanks for the tip, Craig. But I am using the standard 2.7KHz filter for these calibrations. (Indeed, the problem seems to be essentially independent of the filter or mode chosen.)
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Craig Rairdin Sent: Saturday, December 01, 2007 2:19 PM To: elecraft@mailman.qth.net Subject: RE: [Elecraft] K3 Calibration Problem > The real problem is that after setting the power to "exactly > 5.0 watts" and holidng TUNE, the power reading on 160 meters only > goes to 1.2 watts; when I tap TUNE to exit, VFO B says: ERR TXG. > Similar problems on other banads, to wit: 1.8 Watts on 80m, 1.4 > Watts on 40m, 1.9 Watts on 20m, etc. Make sure you've selected a filter that is at least 1 khz wide for CW transmit. Otherwise you'll get the ERR TXG message. Craig NZ0R K3/100 #25 _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com ------------------------------------------------------------ This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email. ================================= _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com