Gordon:
I am on page 21, the 4th step where the bottom of the rear panel is fastened
to the rf board via 4-40 pan head screws. The screw holes in the rear
panel at the bottom have not been countersunk. This causes the screws to
protrude. The holes in the top of the rear panel have been counter sunk.
So the questions are: A, should the holes have been countersunk? B)
should I proceed with assembly and while awaiting a new panel? C) Should I
countersink the holes myself?
I believe you're told to use PAN HEAD screws on the bottom of the case...
73,
Tom N0SS
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
