You should be fine unless you're storing a copy of the firmware on a floppy disk near your assembly area. ;-)
Craig NZ0R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of David Pratt Sent: Sunday, December 09, 2007 12:19 PM To: Elecraft Reflector Subject: Re: [Elecraft] [K3] Assembly In a recent message, Corboy-Poteet <[EMAIL PROTECTED]> wrote ... >This may be common sense and/or mentioned in the Assembly Manual but: >if your Phillips screwdriver does not have a magnetized tip it would >be a good idea to find a magnet and lightly magnetize the tip. Ah, but mind you don't erase the firmware ;-) 73 -- David G4DMP Leeds, England, UK ------ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
