If you read the step or look at the illustrations you'll see what size screw to use and exactly where to use PAN heads and FLAT heads.
Mixing up hardware will do more than produce an ugly K3, it can cause short circuits, bent PC boards and a variety of other not-so-nice situations. That's why each step is very specific about the exact hardware to use, but you really have to read the steps! Ron AC7AC -----Original Message----- I got my K3 yesterday (SN 132, order confirmation 5/1). I am happily assembling it, but I have come across a possible problem. I am on page 21, the 4th step where the bottom of the rear panel is fastened to the rf board via 4-40 pan head screws. The screw holes in the rear panel at the bottom have not been countersunk. This causes the screws to protrude. The holes in the top of the rear panel have been counter sunk. So the questions are: A, should the holes have been countersunk? B) should I proceed with assembly and while awaiting a new panel? C) Should I countersink the holes myself? Gordon, KA2NLM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
