Please update your USB to Serial Adapter driver. There is a link to the Prolific web site in the Troubleshooting section of K3 Utility Help.
73 de Dick, K6KR -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Don Wines Sent: Saturday, January 12, 2008 10:32 AM To: elecraft@mailman.qth.net Subject: [Elecraft] New DSP Firmware won't Load I downloaded the new K3 utility this morning so I could upgrade the K3 firmware. The MCU V1.58 loads OK but the DSP V1.48 won't load. The K3 VFO B area tells me "NEW K3UTIL SOFTWARE REQUIRED * * * *". I have reloaded the K3 utility (V1.1.1.7) but the DSP still won't load. It takes about 10 minutes for the attempt after which the K3 displays "E 000202" in VFO A and "ERR DSE" in VFO B. The manual tells me to reload the DSP firmware which is what I have been trying to do. I am using the Elecraft Serial/USB adapter cable. I have also tried the "Cold Boot" method to no avail. Is there any way to load older (working) versions of the firmware? Don Wines K5DW K3 #123 _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com