I'm sure Don has given this advice before, because on someone's advice here some time ago, I started doing it this way and find I have much better results.
On 01/03/2008 22:13, "Don Wilhelm" <[EMAIL PROTECTED]> sent: > Tony, > > To reduce the width on SSB, try just using Hi Cut instead of the width > and shift controls. Normally when reducing the SSB filter width, the > low end should be near 300 Hz (the K3 uses 250 by default). Keeping the > low frequency corner of the SSB filter fixed at 350 to 300 Hz preserves > intelligibility as the highs are reduced with the Hi Cut control - try > it, you might like it better than fussing with the Width and Shift > controls - I do it that way all the time, no need to adjust the low end > unless the filter is VERY narrow (less than 1400 Hz = Hi Cut at 1650 Hz) -- A person usually has two reasons for doing something: a good reason and the real reason. -Thomas Carlyle, historian and essayist (1795-1881) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
