Same here - one press on XMIT puts the rig in TX, press again and the rig
switches back to RX. I too have MCU 1.78 in my K3.
I also second the proposal for the use of a footswitch - it frees up both
hands. The Heil footswitch is FB quality and reasonably priced.
73 and enjoy the weekend
Glenn ON4WIX
K2/100 #5361
K3/100 #0192
----- Original Message -----
From: "Dave G4AON" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Friday, March 21, 2008 1:31 PM
Subject: [Elecraft] K3 XMIT in SSB modes
Julian
Mine doesn't behave like that, it works as expected and toggles the TX on
/off (MCU firmware 1.78). However for your desk mic, wouldn't a foot
switch be more use?
73 Dave, G4AON
K3/100 #80
----------------------
Having just loaded the latest firmware I find that pressing XMIT in SSB
puts
the rig briefly into TX and then it goes back to RX again. Is this a
deliberate change, or did I imagine that this worked in the first place?
-----
Julian, G4ILO K3 s/n: 222 K2 s/n: 392
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
--
No virus found in this incoming message.
Checked by AVG. Version: 7.5.519 / Virus Database: 269.21.7/1335 - Release
Date: 19/03/2008 9:54
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
