>From page 20 in the K3 Owners Manual - ............................................................................ ....... LINE OUT
STEREO, transformer-isolated; 600 ohm (nominal) These outputs should be connected to your computer's soundcard inputs. The left channel is main receiver audio; the right channel is sub receiver audio (if applicable). The outputs are post- AGC but pre-AF-gain; use CONFIG:LIN OUT to set the level. ............................................................................ ....... I don't see anything about mono there. Looks like they mean it only for stereo connections. 73, Jim ----- Original Message ----- From: "ab2tc" <[EMAIL PROTECTED]> To: <elecraft@mailman.qth.net> Sent: Sunday, April 06, 2008 8:24 PM Subject: [Elecraft] Line out > > Is there any harm done using a mono to stereo adapter in the line out jack in > order to get the signal (no subreceiver installed) in both channels? This > will presumably short-circuit the right channel output on the jack. I am not > using any any of the pseudo-stereo modes. > > Knut - AB2TC > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com