Greetings all,
After upgrading to f/w v1.94 and reading several comments on the list about
auto-zerobeat, I've deliberately used the feature on several CW nets with
all kinds of signals. My overall impression is that it works just fine, but
it seems as if the time it uses to zerobeat has been reduced, so that while
adjusting a CW signal the function may stop during the space between
elements, even if it hasn't quite finished tuning. Several times when I
tapped SPOT to zerobeat a CW signal, the tuning stopped short of zerobeat,
and required one or two more taps to get right on. OTOH, this does not
happen when centering a steady carrier. It just feels like the function
should listen and try a little longer during a space before deciding that
the signal is gone, or zerobeat has been achieved.
Just my $.02 worth....
Van, W1WCG
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
