I am using the Proset marked "IC" which came from Elecraft with my new K3. Inside the instructions said it was for the K2 but I think that was printed before the K3 was around. It has a short Kenwood (red) 8 pin adaptor. It works fine plugged into the front mike connector with the mike bias turned on. Currently the bias is set to high but I understand it will also work with the bias set to low.
Bruce - W8FU -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of John AK4Z Sent: Thursday, May 15, 2008 4:31 PM To: [email protected] Subject: [Elecraft] Heil Proset Plus and K3 Is anyone using a Heil Pro Set Plus IC with a HC-4 and iC electret element with their K3? How did it play? I understand that a Heil Kenwood adaptor (red) is needed to interface with the 8-pin microphone connector on the front of the K3. Is rewiring of the 8-pin Kenwood connector required? Advice/comments regarding setup appreciated. -- View this message in context: http://www.nabble.com/Heil-Proset-Plus-and-K3-tp17261851p17261851.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com -- No virus found in this incoming message. Checked by AVG. Version: 7.5.524 / Virus Database: 269.23.16/1445 - Release Date: 5/15/2008 7:25 PM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
