Yep. Don explained that and it makes sense. I don't know why anyone would want to vary the bias but then again, some folks like to be different. I'm still having a little trouble interpreting some of the menus. I tend to read them quite literally.
Bruce - W8FU -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ken K3IU Sent: Thursday, May 15, 2008 7:05 PM To: Bruce McLaughlin Cc: [email protected] Subject: Re: [Elecraft] Heil Proset Plus and K3 Hi Bruce: The High (H) and Low (L) refer to the gain in the circuit, not the bias level. Tap the display button when you are in the MAIN: MIC SEL mode to read what the "help file" says. 73, Ken K3IU Bruce McLaughlin wrote: > I am using the Proset marked "IC" which came from Elecraft with my new K3. > Inside the instructions said it was for the K2 but I think that was printed > before the K3 was around. It has a short Kenwood (red) 8 pin adaptor. It > works fine plugged into the front mike connector with the mike bias turned > on. Currently the bias is set to high but I understand it will also work > with the bias set to low. > > Bruce - W8FU > Advice/comments regarding setup appreciated. > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com -- No virus found in this incoming message. Checked by AVG. Version: 7.5.524 / Virus Database: 269.23.16/1445 - Release Date: 5/15/2008 7:25 PM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
