Bruce,
The High and Low in the K3 microphone menu refers to the microphone gain
range and has no relationship to the "bias". The bias voltage for the
front panel jack is sourced from +5 volts while the rear panel jack is
sourced from +8 volts. Most electret mics will work with either voltage.
73,
Don W3FPR
Bruce McLaughlin wrote:
I am using the Proset marked "IC" which came from Elecraft with my new K3.
Inside the instructions said it was for the K2 but I think that was printed
before the K3 was around. It has a short Kenwood (red) 8 pin adaptor. It
works fine plugged into the front mike connector with the mike bias turned
on. Currently the bias is set to high but I understand it will also work
with the bias set to low.
Bruce - W8FU
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
