Hi Vic You didn't say, but I assume this is under the most recent firmware download? 73, Bob N6WG
----- Original Message ----- From: "Vic K2VCO" <[EMAIL PROTECTED]> To: "Bob Evans" <[EMAIL PROTECTED]> Cc: <[email protected]> Sent: Tuesday, May 27, 2008 9:33 AM Subject: Re: [Elecraft] K3s in WPX M/S - WOW! > Bob Evans wrote: > > I > > never thought I'd be so happy with a 150 Hz filter bandwidth. Honestly, the > > 100 Hz and 50 Hz bandwidths were useless though as the signal level dropped > > significantly. It seemed much better a few firmware versions ago, but 150 > > Hz worked fine for us...I was just getting "greedy" by trying to use the 100 > > and 50 Hz BW. > > I have just found out that there is a bug that causes a gain reduction > just for these two bandwidths if they are set for FIR filters and not IIR. > > You can fix it now by switching IIR ON, and when Elecraft fixes the bug > you can choose either IIR or FIR for these filters as you prefer. > > To switch between IIR and FIR, tap '7' on the keypad when you're in any > filter setup menu entry (e.g., CONFIG:FLx BW). You want it to say IIR ON. > -- > 73, > Vic, K2VCO > Fresno CA > http://www.qsl.net/k2vco > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
