Dave, Are you in Data-A mode when using audio based PSK31? If so, adjust your filter FC to 1.0. The BW can be what you want it to be, I normally start mine off at 1.0 kHz.
If you transmit your signal right at 1.0 kHz on the waterfall in Data-A it should be the same as when using PSK-D. PSK-D uses a default of 1.0 kHz. But it creates its own audio tones instead of using an external soundcard. If when you are using Data-A you are somewhere other than 1.0 kHz for your audio, then no, the PSK-D signal will not be at the same place, it will always be at 1.0 kHz. Also, when using PSK-D you do not need to adjust the filter FC, it will already be at 1.0 by default. ------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 On Thu May 29 5:44 , Dave sent: >Hi- > On Tuesday, May 27, 2008 8:58 PM, I sent this message to the reflector and haven't seen any comments... maybe I am too anxious, but I am also anxious to cure this problem- so again, I say: > >"Hi- > OK, the K3 works fine using computer generated PSK 31 AFSK, but when I go to >the internally generated PSK 31 D, 31 bps, I do not get responses to my >calling >CQ or calling stations. The TX and RX filter width is set to 2.7 KHz. I can >copy >perfectly on the radios VFO B copy line and do get a kick out of the auto spot >feature. I can hear the transmitted signal on my other rig (ORION II), but it doesn't have the fullness of the AFSK sent PSK. Any ideas? > > On a related note, one poster mentioned the use of the built in ability of > the K3 to notify other net users of external computer problems, maybe so. However when monitoring my AFSK PSK31 signal from the K3 on my OII, I don't see the AFSK PSK31 signal on the same waterfall of the MixW software. That leads me to believe that you can not switch from computer driven AFSK PSK31 to built in PSK D PSK31 because they are on different frequencies. Tell me I am wrong and tell me how ot make it right. > Thanks for the bandwidth. > > 73 de Dave in NH K1OPQ > >_______________________________________________ >Elecraft mailing list >Post to: Elecraft@mailman.qth.net >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
