Thanks Don for the tips: > If you have the KAT2 installed, try changing its R6 value to 470 ohms as a > first step. > If the K60XV is installed, be certain that its VRFDET output is NOT being > enabled when the KAT100 is installed and the low power output is not being > used. > Check RF board D9 to be certain it has not been damaged.
The KAT2/R6 is already 470 ohms and the K60XV has been replaced by its Unmodule to eliminate that possibility. The measurements I had in my past mail were under these conditions. D9 measures output voltage for the base K2 and that's the only power control circuit that works as it should, so I'm pretty confident that D9 is fine. Sverre LA3ZA
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
