Mike,
Check the KPA100 manual - during TUNE the power is reduced to 20 watts.
If you need to TUNE at full power, you can either press the TUNE and
DISPLAY buttons together, or rotate the power knob to the power level
desired after the TUNE operation has started.
73,
Don W3FPR
Mike Short wrote:
I was recently testing a refurbished SB-200 I am working on. I am using my
K2 as the exciter, and had issues on all bands with the K2 remember the
power output
requested. I have connected everthing as follows: K2/100>>MFJ-993 Tuner in
bypass to only show power in and SWR on input circuit of amp,
SB-200>>LP-100 wattmeter>>1KW dummy load.
When I would advance power output from about 10W or so to 70-90W output in
to amp, when I take the K2 out of tune mode, and re-enter, the power would
be 20W or so until I moved the Power knob a bit, then it would go back to
the 70-90W requested. The K2 and the amp are about a foot apart, but the
cover is off the amp, since I was doing some input circuit adjustments.
Maybe I am getting RF back in to the K2?
Mike Short
AI4NS
[EMAIL PROTECTED]
No virus found in this outgoing message.
Checked by AVG.
Version: 7.5.524 / Virus Database: 269.24.4/1476 - Release Date: 5/31/2008
12:25 PM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG.
Version: 8.0.100 / Virus Database: 269.24.4/1476 - Release Date: 5/31/2008 12:25 PM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
