As long as it does NOT force VOX to ON when NOT in SSB Mode but in CW Mode with CONFIG::CW WGHT set to SSB+CW. If it did, you would always have to enter the "TEST" mode to key CW without RF being produced.
Additionally, perhaps we should have a menu choice in terms of invoking forcing CW VOX to ON when in SSB with CW WGHT set to SSB+CW. Folks with QSK amps might just like it the way it is. --Don N4HH -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of wayne burdick Sent: Monday, June 09, 2008 12:34 PM To: Elecraft Reflector Subject: [Elecraft] Re: K3 CW-in-SSB mode: force CW VOX? Joe, I'm OK with this if there are no serious objections to it. It's an easy firmware change. 73, Wayne N6KR > Joe Subich, W4TV wrote: > > > They only suggestion I would make for the firmware is to force > > CW VOX ON while in SSB mode if "Auto CW" is enabled. I generally > > prefer PTT mode for both CW and SSB but it would be handy to > > override CW PTT if Auto CW was enabled. --- http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com No virus found in this incoming message. Checked by AVG. Version: 8.0.100 / Virus Database: 270.1.0/1492 - Release Date: 6/9/2008 10:29 AM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
