GM3SEK wrote: > > At present, selecting MODE=CW will cause the K3's transmitted signal to > jump frequency. To allow the QSO to continue without anyone needing to > re-tune, auto-CW (when enabled) should shift the VFO and display > frequency by the K3's sidetone offset, whenever the mode is changed > between SSB and CW. This is normal behavior in transceivers that fully > support auto-CW. > > The requested change would not affect anyone who has not selected > auto-CW. > Personally I would find this a very nice improvement even though I don't use the auto-CW feature. I often start tuning around in SSB or data mode, and finish up in the CW portion. As soon as I switch to CW mode I lose the signal and have to hunt for it again. Perhaps achieving this would not be as simple as it seems if the sideband used for CW is not the same as is being used for data or SSB. But it would be nice to eliminate that annoyance.
----- Julian, G4ILO K3 s/n: 222 K2 s/n: 392 G4ILO's Shack: www.g4ilo.com Zerobeat Ham Forums: www.zerobeat.net/smf -- View this message in context: http://www.nabble.com/Re%3A-K3-CW-in-SSB-mode%3A-force-CW-VOX--tp17736705p17750402.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
