G'day, OK, just something to unlearn and extra buttons to press. Maybe it could be turned off if not required.
Regards, Mike VP8NO ----- Original Message ----- From: "Lyle Johnson" <[EMAIL PROTECTED]> To: "Mike Harris" <[EMAIL PROTECTED]> Cc: <[email protected]>; "wayne burdick" <[EMAIL PROTECTED]> Sent: Saturday, June 14, 2008 10:24 AM Subject: Re: [Elecraft] K3 - v2.02 |> I upgraded my firmware to v2.02 Friday (13th!) night and now notice the | > following: | > | > Previously the CMP and ALC display option was not available in CW mode. | > Now it is. | | From firwmare release 1.99/1.76, the external ALC input has been activated. | | The ALC display mode must therefore be available in all modes so you can | see if you are overdriving your amplifier, transverter or whatever else | you may have attached tot he K3 that might develop ALC voltage. | | NOTE: DO NOT connect external ALC voltage to your K3 until you have | performed the appropriate hardware modification! Details for this will | be posted to the website. | | 73, | | Lyle KK7P | -------------------------------------------------------------------------------- No virus found in this incoming message. Checked by AVG. Version: 8.0.100 / Virus Database: 270.3.0/1501 - Release Date: 13/06/2008 06:33 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
