Could this be a menu item so we can enable/disable? It seems a bit
confusing because of the display.
Stan
W5EWA
Houston, TX
K2/100 SN 4216
K3/100 SN 0690
Tom Childers, N5GE wrote:
On Sat, 14 Jun 2008 10:14:24 -0400, "Mike Harris" <[EMAIL PROTECTED]>
wrote:
Good day,
I upgraded my firmware to v2.02 Friday (13th!) night and now notice the
following:
Previously the CMP and ALC display option was not available in CW mode.
Now it is. The ALC element of this display shows six units of "ALC" at
any power level when keyed. I guess it isn't supposed to be that way.
I was caught out with this display when changing from 30M CW to 20M where
the K3 was on SSB last time I used it, changed to CW and the CMP/ALC
display stayed active instead of automatically reverting to SWR/RF. Had
me wondering what was going on for a few seconds.
Doesn't make sense to have an irrelevant display option active.
Regards,
Mike VP8NO
[snip]
Seems logical to me. If you are using ALC to control your amp drive it might be
beneficial to see the rig's ALC action on CW. I suspect without an amp ALC line
connected the ALC is telling you the rig is transmitting at the power you set it
at and not being controlled by another device.
That's what I think, but I could be wrong...
Tom, N5GE - SWOT 3537 - Grid EM12jq
"Those who would give up
Essential Liberty to
purchase a little Temporary
Safety deserve neither
Liberty nor Safety"
An excerpt from a letter
written in 1755 from the
Assembly to the Governor
of Pennsylvania.
Support the entire Constitution, not
just the parts you like.
http://www.n5ge.com
http://www.eQSL.cc/Member.cfm?N5GE
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
