I have almost the same probs on 1118 but mine showed during the synth. calibration the following errors: first E00005 - ERR VCO then E00255 - ERR VC4 I sent an email to support and waiting a reply. My K3/100 has firmware 2.02 and it is fitted with 2 opt roofing, KXV3 and KBPF3 (the KPA100 is not installed yet). I checked on the reflector but I'm waiting for the "official" reply. I wish I should not send back any board.
Max IW0GXY http://www.iw0gxy.it www.iw0gxy.it Paul Franson-2 wrote: > > 1114 arrived Friday - all went well until I got to the > synthesizer > calibration. Getting error after the calibration runs > for a brief > period - first get err VCO 00374 , press menu then get > err VC4 00039. > Book says contact support - sent them an email this > morning - while I'm > waiting does anyone else have any ideas on what to > check? > > Thanks > > Paul W2LE > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > -- View this message in context: http://www.nabble.com/K3-VCO-Errors-tp18055021p18064323.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
