The problem reported in my previous post has been fixed. It was my fault because during inspection, before installing the synthesizer board I didn't see a long lead popping out from a quartz. During another inspection i noticed that lead touching the shield. Well, I trimmed it out and the calibration has finally ended without any error. I want to thanks Mike AJ9C for his right intuition about the problem. I wish this could help someone else Max IW0GXY
max iw0gxy wrote: > > I have almost the same probs on 1118 but mine showed during the synth. > calibration the following errors: > first E00005 - ERR VCO > then E00255 - ERR VC4 > I sent an email to support and waiting a reply. > My K3/100 has firmware 2.02 and it is fitted with 2 opt roofing, KXV3 and > KBPF3 (the KPA100 is not installed yet). > I checked on the reflector but I'm waiting for the "official" reply. I > wish I should not send back any board. > > Max IW0GXY > http://www.iw0gxy.it > -- View this message in context: http://www.nabble.com/K3-VCO-Errors-tp18055021p18076239.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
