max iw0gxy wrote:
>
> I have almost the same probs on 1118 but mine showed during the synth.
> calibration the following errors:
> first E00005 - ERR VCO
> then E00255 - ERR VC4
> I sent an email to support and waiting a reply.
> My K3/100 has firmware 2.02 and it is fitted with 2 opt roofing, KXV3 and
> KBPF3 (the KPA100 is not installed yet).
> I checked on the reflector but I'm waiting for the "official" reply. I
> wish I should not send back any board.
>
> Max IW0GXY
> http://www.iw0gxy.it www.iw0gxy.it
>
QRX Max and Paul. There is a firmware update now being tested by Wayne to
improve the synthesizer tuning. I expect it should be released very soon.
73, Bill
--
View this message in context:
http://www.nabble.com/K3-VCO-Errors-tp18055021p18066867.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
