Bud,
The transverter cable needs only 3 signal lines plus ground.
AUXBUS K3 ACC pin 2 to KXVxx pin 6
KEYING K3 ACC pin 10 to KXVxx pin 9
+12 VDC K3 +12 volts output to KXVxx pin 8 (other methods can be used.
but the KXVxx uses this input to sense when the K3 has been turned on).
Ground K3 ACC pin 5 or 12 to KXVxx pin 1.
That should provide you with a transverter that works with the K3. If
it does not work properly, plese let me know.
73,
Don W3FPR
Bud Governale, W3LL wrote:
I'd like to make up a K3 Transverter control cable.
Which pins of the Elecraft Transverter J6 DB-9 connector
are connected to which pins of the K3 AUX I/O?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
