Ian,
Based on information I received from Wayne, I do believe that K3 ACC pin
7 is now dedicated to TX INH. There were complication in sharing it.
If the change is not in the firmware version you are using, it will be
with a forthcoming update. In other words, it cannot be used for XVTR
ON. The +12 volt output from the back of the K3 should do nicely even
though it means "Y"ing out one of the cable wires.
73,
Don W3FPR
Ian J Maude wrote:
Bud Governale, W3LL wrote:
I'd like to make up a K3 Transverter control cable.
Which pins of the Elecraft Transverter J6 DB-9 connector are
connected to which pins of the K3 AUX I/O?
XV DB9 K3 DB15
Pin Pin
1 ground 5
6 auxbus 2
8 XVTR ON 7
9 PTT 10
I hope that makes sense :)
73 Ian
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
