Mike, please make very sure that you're selecting the correct COM port with the K3 utility.
Perhaps it's the cable between your K3 and the PC. There's a long checklist of things to check in the Troubleshooting section of K3 Utility Help. Dick, K6KR -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Mike N8XPQ Sent: Friday, July 04, 2008 5:10 PM To: [email protected] Subject: [Elecraft] K3 Help My K3 is stuck in MCU LD mode. I have tried everything in reference to the com port settings. The K3 utility continues to say K3 not communicating. I have the latest version of the utility and have attempted to re-load 2.10 firmware as well as 2.13 with no luck. I have also tried forcing a firmware load per the manual and directions in the firmware help files. Still no luck. Any ideas????? I really don't want to be with a "dead" rig all weekend. Thanks, Mike N8XPQ ----- Mike Koetje N8XPQ -- View this message in context: http://www.nabble.com/K3-Help-tp18287766p18287766.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
