In N1MM set DTR to CW for COM-1. In the K3 config menu, go to the KEY - PTT menu item and set it to DTR - OFF. That means keying will use the DTR signal and PTT will be OFF.
You can also set PTT in the same manner. In MM, set DTR to CW and RTS to PTT. Then set the KEY - PTT menu to DTR - RTS. Keep in mind I am not by my radio right now and this is from memory. The menu item may be PTT - KEY vice KEY - PTT. If thats the case, you just need to reverse entry, i.e.... RTS - DTR vice DTR - RTS. ------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 On Fri Aug 1 12:35 , "g4mkp" sent: >I would like to move away from LPT keying which consists of a simple >homebrew transistor circuit and use the (or at least try) serial port keying >using N1MM > > > >I have configured N1MM software thus: > >Elecraft K3 on Com1 > >CW box ticked > >Speed 38400 > >Parity N > >Databits 8 > >Stop bits 1 > >DTR always off > >RTS always off > >Radio 1 > >Footswitch (pin6) None > >CW/PTT Port Addr F38 > > > >Rig control works ok but it's not keying the transceiver. Now go easy on me >men I know that it's soooooo obvious to someone what I have/haven't done but >I'm buggered if I know what it is. > > > >Cheers, > > > >Terry > >G4MKP > >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
