Thanks for the assistance. Still can't get it to work with software switches so will look at the hardware interfacing and go through the set-up again in detail.
Cheers, Terry G4MKP > > I would like to move away from LPT keying which consists of a > simple homebrew transistor circuit and use the (or at least > try) serial port keying using N1MM > > > > I have configured N1MM software thus: > > Elecraft K3 on Com1 > > CW box ticked > > Speed 38400 > > Parity N > > Databits 8 > > Stop bits 1 > > DTR always off > > RTS always off > > Radio 1 > > Footswitch (pin6) None > > CW/PTT Port Addr F38 > > > > Rig control works ok but it's not keying the transceiver. Now > go easy on me men I know that it's soooooo obvious to someone > what I have/haven't done but I'm buggered if I know what it is. > > > > Cheers, > > > > Terry > > G4MKP > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
