> I have configured N1MM software thus: > > Elecraft K3 on Com1 > CW box ticked > Speed 38400 > Parity N > Databits 8 > Stop bits 1 > DTR always off
Should be DTR = CW > RTS always off Should be RTS = PTT > Radio 1 > Footswitch (pin6) None > CW/PTT Port Addr F38 K3 Config menu PTT-Key should be: dtr - rts 73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of g4mkp > Sent: Friday, August 01, 2008 3:35 PM > To: [email protected] > Subject: [Elecraft] N1MM Com Port CW > > > I would like to move away from LPT keying which consists of a > simple homebrew transistor circuit and use the (or at least > try) serial port keying using N1MM > > > > I have configured N1MM software thus: > > Elecraft K3 on Com1 > > CW box ticked > > Speed 38400 > > Parity N > > Databits 8 > > Stop bits 1 > > DTR always off > > RTS always off > > Radio 1 > > Footswitch (pin6) None > > CW/PTT Port Addr F38 > > > > Rig control works ok but it's not keying the transceiver. Now > go easy on me men I know that it's soooooo obvious to someone > what I have/haven't done but I'm buggered if I know what it is. > > > > Cheers, > > > > Terry > > G4MKP > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
