Yes. It is the same cable they use for the KXV3 oprtion.
Burl AJ9Q
----- Original Message -----
From: "Iain MacDonnell - K6IAM" <[EMAIL PROTECTED]>
To: "Burl" <[EMAIL PROTECTED]>
Cc: "DOUGLAS ZWIEBEL" <[EMAIL PROTECTED]>; "Elecraft Reflector"
<[email protected]>
Sent: Thursday, August 07, 2008 6:05 PM
Subject: Re: [Elecraft] K3: cheapo substitute for KXV3?
With this cable for the IF out, would one be able to feed a LP-PAN with
full functionality without the KXV3 option?
~Iain
Burl wrote on 08/07/08 15:39:
You can purchase the cable (pn850292 @$3.10) from Elecraft that will plug
into the bottom of RF board at P86. This is the same cable used for the
KXV3 option. It has the 2 pin connector on one end and the other end can
be soldered to a BNC connector. A BNC connector can easily be mounted
in the location of the blank plate that would be used for the KXV3 option
on the back of the radio.
Burl AJ9Q
----- Original Message ----- From: "DOUGLAS ZWIEBEL" <[EMAIL PROTECTED]>
To: "Elecraft Reflector" <[email protected]>
Sent: Thursday, August 07, 2008 1:53 PM
Subject: [Elecraft] K3: cheapo substitute for KXV3?
Okay...so I a typical "cheap" ham....
I would like to save some $$ while still being able to access the "IF
OUT" from the K3. Is there a less expensive (home brew) way to do
this? I don't need any of the xvtr functionality, etc. Just want the
IF output.
I hope Eric and Wayne don't get too upset with this post, but, ummm,
it is still "hands on radio," right? Can anyone help out this non-EE,
non-RF engineer type guy?
:-)
Mni tnx....
de Doug KR2Q
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
